Install the device in 5 easy steps!
The package you've received from Mapon contains:
The Mapon Expert device with a GPS antenna
FMS cable (for detailed location, go to mapon.com/services)
Instruments for removing the tachograph
Tape for securing the device
Mapon is not responsible for errors that occurred before or after the installation of the device, as a non-contact data reader is used to read the data.
1. Check for errors: Start the engine and inspect the tachograph and vehicle dashboard for any error messages. If no errors are displayed, turn off the ignition and proceed with the installation.
2. Find and connect the FMS port: Locate the FMS port (green connector) in your vehicle. Connect it to the green connector on the Mapon cable.
If accessing the FMS port requires removing the tachograph, ensure the yellow connector remains connected and is not damaged.
3. Connect Mapon Expert device: Attach the black connectors to the Mapon Expert tracking device.
4. Check the connection and register the device:
Go to mapon.com/services to check the device connection and perform the tachograph connection test.
Register the device by filling out the form here.
Please note that the ignition must be turned on to check the tacho connection.
5. Finish the installation: Verify that the orange and green LEDs light up once to confirm a successful installation. Place the GPS antenna (magnet side down) — Best: on the roof center, face-up. If installed inside, place it on top of the dashboard near the windshield, close to the centre (not under the dashboard). Secure the Mapon Expert device with a zip tie or tape.
After a successful installation, log in to your Mapon account via www.mapon.com/new. There, you’ll see the registered unit with the device’s serial number in the Map section. Click on the vehicle, then on three dots, choose Vehicle settings to change the number of the vehicle, and fill out its technical information.
Mapon does not take responsibility for the quality of device installation and losses incurred by the customer when installing the device while not following the steps specified in this instruction.
Thank you for choosing Mapon fleet management solutions!
support@mapon.com www.mapon.com