Prerequisites
Top and bottom shaft door anchor rails are added.
Steps
1.) Display the entrance pocket properties. Select the landing door in the drawing, then select the entry pocket object via the Breadcrumb window. The pocket already exists as an element — it only needs a depth to become visible.
2.) Set the pocket depth. The pocket is created automatically for all entries on the corresponding shaft wall side. Shaft sides are independent — front and rear, for example, must be set separately.
3.) Set the pocket width. Switch the pocket width option to Manually.
4.) Set the pocket height. Define it either relative to the door height or relative to the finished floor.
5.) Define individual pockets for specific floors. Use the grouping function to give a single floor a different pocket size.
6.) Define the depth via the shaft dimensions. The pocket depth can also be set quickly using the shaft dimensions.
Result
Entrance pockets are created with the required depth, width, and height per shaft side, with individual sizes for specific floors where needed.
Next Step