Prerequisites
Individual shafts in the group can be edited separately.
Pitfall: Pay attention to the wall thickness of the shaft when adapting the separator beam's position.
Steps
Group shaft wall opening and shaft positions
1.) Understand the automatically created group shaft wall opening. A wall opening is automatically created when adding a new elevator to the group, visible in Design Mode. It's always created at the previous shaft.
2.) Remove or add a wall opening via Additional Objects. Remove the automatically created wall opening via the Additional Objects docking window, or add a new one the same way if needed.
3.) Move a shaft through the coordinate system. Move shafts by editing the coordinate system in the corresponding Properties.
Separator beam
4.) Activate the separator beam. Activate it via the BracketList → Fixing Options → Separator Beam: Yes.
5.) Adapt the separator beam's position. Adjust its position via Distance to Wall.
Result
You understand where the automatic group shaft wall opening comes from, how to remove or add one via Additional Objects, how to reposition a shaft using its coordinate system Properties, and how to activate and position a separator beam between adjacent shafts.
Next Step