Prerequisites
The fixing points now position themselves automatically at the shaft wall and at the correct top/bottom location on the landing door.
Steps
1.) Select the manufacturer's common left and right fixing points. In DigiPara Liftdesigner Datamanager, open the Common Components manufacturer module and mark the left and right fixing point columns by holding Ctrl and selecting both.
2.) Paste the data rows into your own new fixing group. Switch back to your manufacturer module, select the first existing row in the current table, and paste (Ctrl+V) the copied data rows in.
3.) Define the position of the left and right fixing points in Z-direction. Set the Z-direction position for both the left and right fixing points.
4.) Determine the door width range. Set the door width range these left/right fixing points apply to.
Result
The landing door's fixing group now also includes correctly positioned left and right fixing points, reused from the shared Common Components module.
Next Step